Saddle Up With Our Summer Adventure Guide—Shop Now
Home Page

Detail Images

Current Color

Park Tool SG-6 Threadless Fork Saw Guide

Add Protect+ Powered by Extend™

Cut it straight.

Get rid of that unsightly spacer stack and chop a little off the steer tube with the Park Tool SG-6 Threadless Fork Saw Guide. The SG-6 helps you make a straight, even cut on your sub-1.5-inch steer tube.

  • Compatible with 1-inch, 1.125-inch, and 1.25-inch steer tubes.
  • Item #PAR0077

Recommended Use
trimming steer tubes
Manufacturer Warranty
limited lifetime
steer tubes less than 1.5 inch

Tech Specs

What do you think about this product?


>Rating: 5

Right tool for the job.

I've put it through the wringer

When you need to cut down a steerer tube, handlebar, or seatpost, this is a must-have. Like everything Park Tool, it is well made and will last forever.

>Rating: 4

Works Great

I've put it through the wringer

Works great for making straight cuts on a steer tube. Super east to use.

>Rating: 5

Not a fan of pipe cutters

I've put it through the wringer

I like using the hacksaw guide as I think it leaves a better cut than a pipe cutter. In the past when I've used a pipe cutter I've gotten a raised edge that needed to be filed down, and was more of a hassle than cleaning up the edge the hacksaw left. It does take a bit more to make sure you line up your cut correctly, but some care this should be the last guide you need to purchase.

>Rating: 4


I've put it through the wringer

This tool is a little messy and you get cuttings everywhere when you use a hacksaw. Stuff you don't wont mingling with your sanctions and seals. It does do a great job except for the mess and and is very will made. I have to agree with Scott on using pipe cutters is a great tool

>Rating: 4

Liked it until I discovered pipe cutters

If you have a carbon steerer this will not apply to you, you should get this thing and love it. If you have all alu steerers as I do, this thing will work fine. It'll give you a reasonably clean and even cut. I prefer using a good pipe cutter to this, though, and then filing the lip down as it will get an even cleaner and more even cut. Whatever you do don't free-hand it, that'll turn out crappy. This thing works, it's just for alu steerers a pipe cutter works better.