Temporarily Out Of Stock
Don't get too bummed. This item is on the way and will be available for purchase as soon as it rolls into the warehouse.
Can't wait? Consider one of the other Gravel & Cyclocross Drop Handlebars we have in stock.View Similar Products
The ENVE SES Aero Road Handlebar is built for one thing: going fast. It's ENVE's first foray into internal cable routing, resulting in a clean look that cuts through the air. The flat, wide top section of the bars slices wind when you need speed and provides a big platform for resting tired hands at the end of an interval. The drops have a similar profile as ENVE's standard compact road bar, with the bar ends flaring out slightly wider than the top of the bar to offer a wide range of hand positions to get comfy and aero in the drops.
Please note that the bars are measured center-to-center from the bar ends, which are wider than the tops. ENVE recommends ordering a size up from normal if you spend most of your ride time on the hoods and tops.
- Carbon fiber
- Aerodynamic design
- Internal cable routing
- Bar ends flared wider than top width
- Width measured center-to-center at bar ends
- 31.8mm diameter at clamp
- Item #ENV000C
- Q & A
Great Aero Bar
- Familiarity: I've used it several times
I installed this bar in my Scott Foil. Very light and stiff. The upper flat portion of the bar is very comfortable under my medium hands while climbing.
Vibration damping is excelent!!
Measure your stem first...
Clamp area is 48mm
Are these 1st or 2nd generation?
Hi Scott, these are the first generation of the bars, we have the newer version under part number ENV004A.
After mounting these in the stem is there...
After mounting these in the stem is there room for a K-edge garmin mount next to the stem before the bar flares out?
There should be enough room for the K-Edge , but that depends on the width of you stem.
I have this aero bar mated to the ENVE Stem. Granted, mine are both painted to match, so tolerances were slightly tighter, but there is little to NO room for most mounts.
I tried all Bar Fly's, the K-edge (too tight), and Garmin's mount; none worked. I finally squeezed a mount found on amazon labeled as "SRAM". It sits a bit far out, but does the job. Otherwise, attach to stem where I couldn't see it well. I will try again with a Bar Fly & a dremel to get a better fitting mount. Cheers, Jeff
I know Enve wants to maximize the airfoil section of the bar, but why they had to make the clamp width section SO narrow is beyond me. I am a big-time aero weenie sprinter and these bars would be perfect for me BUT I likely will have to go with the SL-70s because of the narrow clamp width and the inability to use mounts (what's the fun of racing if you can't GoPro and share with your buddies, right?)
Enve has their own computer mount now. http://enve.com/products/gear/computer-mount-cmptrmnt/
Short answer: NO. It sounds crazy, but I've owned these bars and it was impossible to put ANY bar mounted accessory.