Saddle Height Bullet

What Our Gearhead® Experts Are Saying:

"The Saddle Height Bullet sounds simple until you realize how much of your saddle height measurement depends on where you anchor the tape at the bottom bracket. It drops right into the Shimano crank bolt or preload cap and gives you a consistent, centered starting point every single time. Paired with a saddle plate, this is the piece of the system that makes millimeter-level repeatability actually possible."

Saddle height measurement is only as accurate as where you start it. Most mechanics know the saddle end of the measurement well, but the bottom bracket end is where imprecision quietly creeps in. The Abbey Bike Tools Saddle Height Bullet solves that problem cleanly, using a magnetic design that locates directly into the Shimano crank arm fixing bolt or preload cap to establish a true center at the bottom bracket every time.

Available in 8mm and 10mm sizes to cover the most common Shimano crank configurations, the bullet seats magnetically and holds position while you focus on pulling an accurate measurement up to the saddle. For anyone doing fit work, building up bikes for clients, or just trying to replicate a dialed position after travel or a component swap, this is the detail that makes the difference between close and correct.