RockyMounts

Anti-Wobble Block Assembly 4.5mm Tubing

What Our Gearhead® Experts Are Saying:

"I installed this on my BackStage after noticing more lateral movement than I wanted on rough roads and the difference was immediate. The ball bearing design locks the rack into the receiver without any of the slop that causes that constant low-grade rattle on the highway, and the install took about five minutes with basic tools."

Rack wobble is one of those things that starts as a minor annoyance and compounds into a genuine distraction over a long drive to the trailhead. The RockyMounts Anti-Wobble Block Assembly for SplitRail and BackStage addresses it directly, integrating into the hitch tube with a 3/4in ball bearing and two M6 screws to lock the rack into the receiver and eliminate the lateral movement that causes noise, wear, and the nagging feeling that something is not quite right back there. High-strength steel construction with a corrosion-resistant finish keeps the assembly performing through seasons of outdoor exposure without degrading the fit it was installed to create.

At approximately one pound it adds nothing meaningful to the overall setup weight while removing something that was quietly undermining every drive. It is the kind of fix that makes the whole system feel more intentional from the moment it is installed.