I bought new K2 Work Stinx and was thinking of putting these bindings on them. What does it take to put them on, do they match up with the predrilled inserts.

Putting epoxy in the screws won't do anything. If they're going to rip out, they're going to rip out. All your going to do by putting epoxy in there is to make sure the bindings don't come out with a screwdriver either. NEVER use epoxy when mounting skis. BD says use wood glue. Titebond is enough. I realize this is probably too late to help you, but if anyone else sees this, DON'T USE EPOXY!

Hey Gary, do remember that if you are using stiffer cartridges and stiffer boots with these (like t-races or customs), to epoxy the screw holes. The four-screw pattern plus the underfoot cable system puts a tremendous amount of torque on the back two screws which can rip them out of your skis. My O1s (which have the same screw pattern) ripped the inserts OUT of my K2 Anti-Pistes, so make sure to tell the shop to epoxy the crap out of the insert holes...

thanks Angus, Gary

These fit the K2 inserts perfectly, I've skied Hippy Stinx, Piste Pipes, Super Stinx, World Pistes, and Work Stinx all with O2s and they've all been bomber.