- Home
- Metolius Simulator CNC Training Board
- Question and Answer
Gear Question
Metolius Simulator CNC Training Board
Will this fingerboard support weight if it is attached into ...
By Peter Z
Ranked #988 - Climbing Accessories and Training
November 23, 2008
Will this fingerboard support weight if it is attached into drywall?
View Details: Metolius Simulator CNC Training Board
Helpful Votes: 0 Yes
By Jake McRae
Ranked #109 - Climbing Accessories and Training
April 10, 2009
No. it will fall right out
Helpful Votes: 0 Yes
By Benjamin Herndon
Ranked #575 - Climbing Accessories and Training
February 15, 2009
Peter, Metolius recommends that you first mount the Simulator to a 5/8" or 3/4" piece of plywood, then mount the plywood to studs above a doorway. You can find these instructions at www.metoliusclimbing.com/howto-installboards.htmJC--Metolius recommends that the plywood be anchored into at least two (preferably three or four) studs. By mounting it on the plywood first, the weight is distributed evenly over the studs. It also provides a spacer so that the hangboard is flush with any trim around the doorway.
Helpful Votes: 0 Yes
Change me.