MSR HyperFlow Microfilter

Backflush is not that that difficult, but I recommend that you try it at home first just to figure out so you don't have to bring the instructions with you. The only issue I had, which would probably be the same for all pumps, is keeping the inlet submerged. I ended using a spare water bottle, stuffing the inlet screen and tube into that, at using a rock to weigh it down. That worked fine.

I have only used this one time, but so far its worked flawlessly. Small and lightweight, pumps wicked fast.

A group of 7 of us went into the Sierra on a 3 day trip. We were using my old Pur filter which has been a trusty unit for 10 years. But then my friend (who doesn't backpack much) pulled this thing out of her pack. I got first crack at using it, and I was blown away. It pumped my platypus full in less than 60 seconds. I couldn't believe how small this thing is and how smart the design is. However, my opinion changed later that night when I borrowed it again, and could barely get it to function. Instead of seconds, it took 10+ minutes to pump the same amount of water. Granted, I don't know what happened in the intervening hours, but I don't think the filter was misused by anyone. All the water we were filtering was very clean and clear. The next morning I took it apart and couldn't find anything dirty, clogged or otherwise gummed up. Still, it refused to pump water at any kind of reasonable rate. At that point, it was essentially a tiny workout device.

Worked great in sink, terrible on Vancouver Island's North Coast Trail and later (with a new one) on Vancouver Island's Strathcona Park. on the NCT, murky creek water clogged the filter and backflushing on trail would not improve pumping speed/effort within 60% of original levels. Thorough backflushing in sink at home returned filter to 80% of original pumping speed/effort. Replaced with a new one and took to the alpine (nice clean water) and had the same problems. Backflushing this time on the trail and extensively at home only replaced the unit to 60% of original values. Would not recommend this. IMO it's job should be to filter water for you, no matter where you are. It is amazingly light and small though (and originally pumped wicked fast)

Do not buy this pump. Three of us used it on a seven day trip. Each of us experienced the same hard to pump problem that other experienced and frustrated hiking brothers have shared. Although we pumped from clear clean sourced and followed the instructions for backflushing to the letter this pump FAILED with a capital F. It didn't work and we all ended up using another brand that one of our fellow hikers brought. MSR owes many of us trusted customers an explanation and refund.

This was my first filter - boyfriend's 3rd, and he was far more impressed than I was. Using creeks and streams in the Cascades, we had no problems filling this up. Didn't need to do the backflush at all, but after 9L figured we would. If you follow the directions it's a snap. It's not an all-purpose filter, but works for us.

I am not sure where and how some of the reviewers used this filter, or why they are writing such negative reviews. I have been hiking and using filters now for 15+ years (Katadyn, Sweetwater - and they also work fine, but slower). Just used this one again on 7 day trip up north (Fort Nelson area)for group of 3. Water was mostly from creeks of various clarity. No problem with the float end at all, actually it works great! We had 3 filters, but after the first use we only use HyperFlow. My partners wanted to buy it from me right there! Easy to use, very light, fastest flow by far when compared to anything comparable. All filters plug up and slow down in silty water, so what? It is so easy to back flush (best to do right after watering up and it takes me about one minute). True, I have not use it to try to pump water from a puddle so far, but I had only do it once in last 10 years. I am sure it can be done, but it may take a little longer to get your 4-6 liters done. For now I say if you like lite and fast, buy it, you'll love it! Excellent gear!

This filter did NOT live up to expectations. The float end wouldn't stay face down in the water. Even worse, the filter cartridge clogged very easily when the water wasn't perfectly clear (e.g., when there's any presence of algae). The only way to backflush was to waste up to 1 liter of water for every 8 liters you pump -- you can't clean the filter directly like other MSR ceramic filters. Definitely not worth the extra money. Go with a proven and cheaper MSR pump instead (such as the Miniworks EX).

I recently spent 5 days at lakes above 10,000 in the Sierras. I pumped mostly in running streams. The filter clogs really fast. Backflushing doesn't take too long but it never recovered and was a pain to pump. I'll stick with my MSR miniworks. It's worth the extra 9 oz or so.

I've been backpacking and climbing for over 20 years (I hate saying that...) and this is the best thing I've ever used to filter water. I'd been using it off and on on shorter trips in the Cascades and was blown away - but that's easy for most filters to accomplish. So, the proof was to be found on an 8-day trip in the High Sierras and I even bought a spare filter cartridge just in case. My research had turned up some folks griping about clogging etc. but I can only imagine that they were doing something wrong or filtering REALLY silty water. True - it does slow down if you are filtering really silty water. I noticed the difference between a glacial-fed lake and some others that were lower - but we backflushed as recommended (every eight liters, or about once every other day for two people) and had no problem whatsoever. And for those worrying that backflushing that much is too much - think again. You'll never even consider going back to another filter after realizing how much easier the Hyperflow is. We got used to backflushing right as we finished filtering and it only added about 1-2 minutes - Far less than the time saved by the Hyperflow's speed and the overall ease of pumping more than makes up for any inconvenience you thought you might have felt. We even started to routinely do the filter test at the same time because it was so easy to do in the process. I will say that I wouldn't use it in direct glacial meltwater and I have no idea how it would do in the Canyonlands or other places with really murky water, but I'm guessing it might not be the best choice there. However, if you want to get a superlight, and really small filter for taking on alpine trips or anywhere the water is pretty clear, I can't imagine a better set-up. I even take it on day hikes and car-to-car alpine climbs now and pump as I go. It beats lugging two camelbaks around in my pack or dealing with the taste and hassle of iodine. Oh, and I still haven't touched that spare filter cartridge.

I've been backpacking and climbing for over 20 years (I hate saying that...) and this is the best thing I've ever used to filter water. I'd been using it off and on on shorter trips in the Cascades and was blown away - but that's easy for most filters to accomplish. So, the proof was to be found on an 8-day trip in the High Sierras and I even bought a spare filter cartridge just in case. My research had turned up some folks griping about clogging etc. but I can only imagine that they were doing something wrong or filtering REALLY silty water. True - it does slow down if you are filtering really silty water. I noticed the difference between a glacial-fed lake and some others that were lower - but we backflushed as recommended (every eight liters, or about once every other day for two people) and had no problem whatsoever. And for those worrying that backflushing that much is too much - think again. You'll never even consider going back to another filter after realizing how much easier the Hyperflow is. We got used to backflushing right as we finished filtering and it only added about 1-2 minutes - Far less than the time saved by the Hyperflow's speed and the overall ease of pumping more than makes up for any inconvenience you thought you might have felt. We even started to routinely do the filter test at the same time because it was so easy to do in the process. I will say that I wouldn't use it in direct glacial meltwater and I have no idea how it would do in the Canyonlands or other places with really murky water, but I'm guessing it might not be the best choice there. However, if you want to get a superlight, and really small filter for taking on alpine trips or anywhere the water is pretty clear, I can't imagine a better set-up. I even take it on day hikes and car-to-car alpine climbs now and pump as I go. It beats lugging two camelbaks around in my pack or dealing with the taste and hassle of iodine. Oh, and I still haven't touched that spare filter cartridge.

I have owned the hyperflow for a close to two months now and I think it's awesome. I'm always a little skeptical of new filters but I've pumped some sketchy looking water and I didn't get sick at all. I was trying to convince my hiking partner to take water straight from the source but he refused. This filter is way faster than my old sweetwater. The only problem I've been having is not realizing my camel back was full it popped off my drinking tube and sprayed all over. Great product from MSR.

After filtering 8 liters of water from a clear mountain stream this thing clogged. No amount of backwashing per the directions could fully restore it. It never pumped 3 liters per minute as claimed. The best thing I can say is that I got a good bicep workout trying to push the plunger down. Someone else in my party carried a Katadyn Vario which functioned perfectly. This is junk...don't waste your money.