can the liners on these boots be molded...
can the liners on these boots be molded more than once?
Theoretically yes. I have both the Factor and Push from BD and am very satisfied with both boots. The Push uses the same thermo-mouldable liner as the Method. Most of the time just putting the boots on and either skiing a few laps or walking around for about 15 minutes will warm up the foam enough for it to mould to your feet sufficiently. If you do decide to pop them in the oven make sure you stay lower than about 150 F with the blower. Be careful with over-cooking the any boot liner - if it's too hot for too long the sole glue has a tendency to get soft and loosen itself. Also, if the liner has been used for more than a full season then it will might stink in the oven - it's OK just make sure the wife/GF is out of the house and the windows are open :) Hope this helps!
follow up question...I'm scared to heat mold my liners. seems like the plastic parts from the boa system could get messed up. any advice for me here? otherwise I love these boots.